Part Description: 2007 Chevrolet Malibu Spin-On Lube Engine Oil Filter
More Info
Vehicle Fitment
2007 Chevrolet Malibu | All Trims | 6 Cyl 3.9L
2007 Chevrolet Malibu | All Trims | 6 Cyl 3.5L
FAQ for Oil Filter Repair
Q: How do I remove the engine oil and filter?
A:
Start with lifting and supporting the vehicle, next you will need to place a drain pan under the oil drain plug. Then remove the oil drain plug and use the oil filter wrench to remove the filter cap. Lastly, remove the oil filter from the cap.
By Bob
GM Specialist
25/03/2022
Q: How do install the engine oil and filter?
A:
Start with installing the filter to the cap and then installing the cap with the filter. Use the oil filter wrench to tighten the cap. Then install the oil drain plug, lower the vehicle and fill it with engine oil.
By Omar
GM Specialist
24/03/2022
Q: What is the engine oil and oil filter installation procedure?
A:
First, install the filter to the cap and the oil filter cap with the filter. Next, tighten the oil filter cap until fully seated. Install the oil pan drain plug and tighten the oil pan drain plug to 25 Nm.
By Bob
GM Specialist
22/03/2022
Q: What special tools will I be needing when servicing the oil filter cap?
A:
You will need an Oil Filter Wrench.
By Omar
GM Specialist
17/03/2022
FAQ for Other Repair Info
Q: How do I install the oil pan?
A:
You need to ensure that the Oil Pan and the sealing surface on the lower crankcase are free of all oil and debris, and apply a 2 mm (0.079 in) bead of sealant around the oil pan. Next, attach the oil, install the lower air conditioning (A/C) compressor bolt and the engine drive belt, lower the vehicle, and then fill the crankcase with oil.
Q: What is the oil pump installation procedure?
A:
Install the Oil Pump to the valve body, install the oil pump bolts and connect the electrical connectors to the solenoid valves. Finally, install the case side covers.
Q: What is the oil level indicator and tube installation procedure?
A:
First install the oil level indicator tube seal, the oil level indicator tube, and the indicator tube bolt. Tighten the bolts to 10 Nm. And install the oil level indicator. Next, install the knock sensor electrical connector clip and the air cleaner outlet resonator.