Part Description: 2007 Chevrolet Malibu Pipe Asm-Fuel Tank Filler
More Info
Vehicle Fitment
2007 Chevrolet Malibu | Base, Classic LS, Classic LT, LS, LT, LTZ, Maxx, Maxx LS, Maxx LT, Maxx LTZ, Maxx SS, SS | 4 Cyl 2.2 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.9 L GAS
FAQ for Fuel Filler Hose Repair
Q: How do I inspect for leaks?
A:
Turn ON the ignition, with the engine OFF for 10 seconds Turn OFF the ignition for 10 seconds. Turn ON the ignition, with the engine OFF. Inspect for fuel leaks.
By Bob
GM Specialist
28/03/2022
Q: What is the recommended bolt torque for the fuel fill pipe hose clamp?
A:
The recommended bolt torque is 4 Nm (35 LB IN).
By Bob
GM Specialist
18/03/2022
Q: What is the recommended bolt torque for the fuel tank fill pipe to the fuel tank fill pipe housing bolt?
A:
The recommended bolt torque is 1.5 Nm (13 LB IN).
By Bob
GM Specialist
18/03/2022
Q: What is the recommended bolt torque for the fuel tank fill pipe to the underbody side rail bolt?
A:
The recommended bolt torque is 9 Nm (80 LB IN).
By Omar
GM Specialist
18/03/2022
Q: What should be done before servicing the vehicle?
A:
Remove the fuel cap and drain the fuel tank.
By Omar
GM Specialist
17/03/2022
FAQ for Other Repair Info
Q: How do I install the fuel injectors?
A:
Lubricate the new injector O-rings with clean engine oil. Install the new Fuel Injector upper O-ring, the new fuel injector lower O-ring, the fuel injector, the fuel injector retainer, and the fuel rail.
Q: How do I remove the fuel level sensor?
A:
Start with removing the fuel pump module assembly and releasing the Fuel Level Sensor wiring harness from the molded-in tab on the pump module bowl. Next, you will need to disconnect the fuel level sensor electrical connector from the pump module cover and depress the retaining tab on the sensor and begin to slide the level sensor away from the pump module. Carefully slide the level sensor the rest of the way off of the pump module.
Q: How do you remove the fuel tank pressure sensor?