Part Description: 2007 Chevrolet Malibu Bracket-Engine Mount
More Info
Vehicle Fitment
2007 Chevrolet Malibu | Maxx SS, SS | 6 Cyl 3.9 L GAS
FAQ for Engine Mount Repair
Q: How do you adjust the engine mount position?
A:
You can loosen the front/rear transaxle mount, rock the engine, and tighten the bolts.
By Bob
GM Specialist
24/03/2022
Q: What is the engine mount bracket installation procedure?
A:
First, install the intermediate bracket to the engine and hand tighten the engine mount intermediate bracket bolts. Next, tighten the intermediate bracket bolts to 100 Nm. Finally, install the engine mount.
By Omar
GM Specialist
22/03/2022
Q: What is the engine mount bracket removal procedure?
A:
First remove the engine mount, the intermediate bracket to engine bolts, and the intermediate bracket from the engine.
By Bob
GM Specialist
22/03/2022
Q: What is the engine mount installation procedure?
A:
First, install the engine mount to the vehicle and hand tighten the bolts at this time. Install the engine mount to the engine bracket bolts and remove the floor jack and block of wood. Finally, install the air cleaner assembly.
By Omar
GM Specialist
22/03/2022
Q: What is the engine support installation procedure?
A:
First, raise the hood and install the thread support nuts onto the strut attaching nuts. Next, install the strut tower support assemblies over the thread support nuts and install the T-bolts with 5/16 inch washers through the strut tower support assemblies. After that install the two cross bracket assemblies over the strut tower tube and install the strut tower tube into the strut tower support assemblies.
By Omar
GM Specialist
22/03/2022
Q: What is the proper way to balance the power train mount?
A:
The proper way is to loosen the front/rear transmission mount, rock the power train, and tighten the bolts.
By Bob
GM Specialist
21/03/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: How do I install the Blower Motor Resistor?
A:
Start with installing the Blower Motor Resistor, the blower motor resistor wire harness connector, and the right closeout panel.
Q: How do I install the blower motor?
A:
Start with installing the motor blower seal, the Blower Motor, the blower motor attachment ring if reusing the blower, the blower motor wire harness connector, and the right closeout panel.
Q: How do I install the fuel injectors?
A:
Lubricate the new injector O-rings with clean engine oil. Install the new Fuel Injector upper O-ring, the new fuel injector lower O-ring, the fuel injector, the fuel injector retainer, and the fuel rail.