2007 Chevrolet Malibu | Classic LS, Classic LT, LS, LT, LTZ, Maxx LS, Maxx LT, Maxx LTZ, Maxx SS, SS | 4 Cyl 2.2 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.9 L GAS
FAQ for Door Latch Assembly Repair
Q: What is the liftgate latch service procedure?
A:
First, remove the rear compartment sill plate and tighten the liftgate latch bolts to 10 Nm.
By Bob
GM Specialist
21/03/2022
Q: What is the part number for the door latch when it freezes?
A:
The part number is 12346241 for the super lube.
By Omar
GM Specialist
21/03/2022
Q: What is the part number of the solution for the door latches that freeze in the cold?
A:
The part number is 12346421 for the lube that helps with frozen door latches.
By Bob
GM Specialist
21/03/2022
Q: What is the rear compartment lid latch installation procedure?
A:
First, lace the latch assembly into the rear compartment lid and connect the latch wiring harness connector. Next, install the latch assembly bolt and tighten the bolts to 10 Nm. Finally, install the lock rod to the lock clip.
By Bob
GM Specialist
18/03/2022
FAQ for Other Repair Info
Q: How do I install the power door lock switch?
A:
Start with installing the switch to the bezel, and next connect the electrical connector to the Door Lock Switch. Then install the door handle bezel to the door trim and the door trim panel.
Q: How do I remove the Front Side Door Check Link?
A:
Start with removing the door trim panel, the water deflector, the front Door Check link bolt, the front door check link nuts, and the front door check link from the door.
Q: How do I remove the front side door hinge?
A:
Open and support the door, then clean off the hinges and mark the spot they are installed to. Remove the front door, the hinge pillar bolts and nuts, and the front Door Hinge from the vehicle.