Other Names: Composite Headlamp, Headlamp Assembly
Item Dimensions: 27.0 x 12.4 x 10.4 inches
Item Weight: 7.30 Pounds
Fitment Type: Direct Replacement
Replaces: 15775402, 15942839, 15846362
Part Description: 2007 Chevrolet Impala Composite Headlamp
More Info
Vehicle Fitment
2007 Chevrolet Impala | 50th Anniversary Edition, LS, LT, LTZ, Police, SS | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
Other Names: Composite Headlamp, Headlamp Assembly
Item Dimensions: 27.4 x 12.6 x 10.6 inches
Item Weight: 4.90 Pounds
Fitment Type: Direct Replacement
Replaces: 20988133, 15775403, 15846363, 15942840
Part Description: 2007 Chevrolet Impala Composite Headlamp
More Info
Vehicle Fitment
2007 Chevrolet Impala | 50th Anniversary Edition, LS, LT, LTZ, Police, SS | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
$228.10MSRP: $344.12
You Save: $116.02 (34%)
FAQ for Headlight Repair
Q: What is the purpose of pulling outward on the housing?
A:
The purpose is to access the electrical connector.
By Bob
GM Specialist
04/04/2022
Q: What is the removal procedure for the socket?
A:
You can remove the lamp assembly and then remove the bulb.
By Omar
GM Specialist
31/03/2022
Q: What should you do if the socket is not discolored or damaged?
A:
You should replace only the bulb with P/N 92095787.
By Bob
GM Specialist
30/03/2022
Q: What should you remove before replacing the headlamp bulb?
A:
You should open the hood and remove either the LH or RH headlamp assembly.
By Bob
GM Specialist
29/03/2022
FAQ for Other Repair Info
Q: How do you install the starter motor?
A:
You can install the following: the Starter bolts, the engine harness terminal, and positive battery cable terminal, the starter solenoid BAT terminal nut, the torque converter covers, and the front lower air deflector panel.
Q: What should you remove before replacing the body control module?
A:
You should remove the left closeout panel. After replacement, you should program the Body Control Module.
Q: What should you remove before replacing the sunroof motor/actuator?
A:
You should remove the following: the carpet retainer, the sunshade, the pillar garnish molding, the upper center pillar, the rear upper quarter trim, the rear window trim, the headliner, and the Sunroof Motor/actuator.