Part Description: 2007 Chevrolet Impala Air Intake Hose
More Info
Vehicle Fitment
2007 Chevrolet Impala | All Trims | 6 Cyl 3.5L
2007 Chevrolet Impala | All Trims | 6 Cyl 3.9L
$53.00
FAQ for Air Intake Hose Repair
Q: How can you install the air injection pump hose?
A:
You can position and connect the AIR pump hose quick connect fitting to the AIR pump and connect the AIR pump hose quick connect fitting to the air cleaner assembly.
By Omar
GM Specialist
08/04/2022
Q: How do you install the air cleaner outlet duct?
A:
You can install the air cleaner outlet duct from the MAF/IAT sensor, install the air cleaner outlet duct to the throttle body and install the intake manifold cover.
By Bob
GM Specialist
08/04/2022
Q: How do you install the air injection feed tube?
A:
You can install the AIR feed tube bolt to the heater inlet/outlet pipe bracket and install the air cleaner outlet duct.
By Omar
GM Specialist
08/04/2022
Q: How do you install the AIR injection pipe?
A:
You should install one middle AIR pipe bolt to the pipe, install the new AIR pipe gaskets to the studs and the bolt, install the AIR pipe, install the remaining AIR pipe bolts, install the AIR check valve nuts and install the catalytic converter.
By Bob
GM Specialist
08/04/2022
Q: What is the recommended bolt torque when installing the AIR feed tube bolt to the heater inlet/outlet pipe bracket?
A:
The recommended bolt torque is 10 N.m (89 lb in).
By Omar
GM Specialist
04/04/2022
Q: What is the recommended bolt torque when installing the remaining AIR pipe bolts?
A:
The recommended bolt torque is 10 N.m (89 lb in).
By Bob
GM Specialist
04/04/2022
Q: What is the recommended nut torque when installing the AIR check valve nuts?
A:
The recommended nut torque is 10 N.m (89 lb in).
By Bob
GM Specialist
04/04/2022
Q: What is the recommended torque for the air cleaner outlet duct clamp at the MAF/IAT sensor?
A:
The recommended clamp torque is 3 N.m (27 lb in).
By Omar
GM Specialist
03/04/2022
Q: What is the recommended torque for the air cleaner outlet duct clamp at the throttle body?
A:
The recommended clamp torque is 3 N.m (27 lb in).
By Bob
GM Specialist
03/04/2022
Q: What is the removal procedure for the Air Cleaner Outlet Duct?
A:
The procedure is to remove the intake manifold cover, disconnect the positive crankcase ventilation tube, and remove the air cleaner outlet duct from the throttle body as well as the air cleaner outlet duct from the MAF/IAT sensor.
By Omar
GM Specialist
02/04/2022
See more FAQs (8)
FAQ for Other Repair Info
Q: Does the use of an aftermarket reusable air filter void the vehicle's warranty?
A:
No, the use of an aftermarket reusable Air Filter does not void the vehicle's warranty.
Q: How do you install the manifold absolute pressure sensor?
A:
You can install the following: the MAP Sensor seal, the MAP sensor and bracket, the upper intake manifold bolts, the spark plug wire clip, and the intake manifold cover.
Q: What is the removal procedure for the lower intake manifold?
A:
The procedure is to remove the following: the upper Intake Manifold, the left valve rocker arm cover, the right valve rocker arm cover, the fuel injector harness connector bracket bolt, the fuel injector rail bolts, the fuel rail, the lower intake manifold bolts, and the lower intake manifold.