2007 Chevrolet Equinox Sunroof Handle

You will need to cycle the sunroof window to the vent position, then slide the sunshade rearward, and remove the sunroof window screws on both sides, finally lift the sunroof window from the sunroof opening.

You will need to cycle the sunroof window from fully open to closed position first, then loosen the adjusting screw, and adjust the corners of the glass panel using the following guidelines: adjust the front of the sunroof window flush to 1 mm (0.04 in) below the top surface of the roof panel, adjust the rear of the sunroof window flush to 1 mm (0.04 in) above the top surface of the roof panel. Then you can install the sunroof window adjustment screws, cycle the sunroof window through all positions and inspect the sunroof window adjustment.

The recommended torque is 5 N.m (44 lb in).

You may need to position the sunroof window into the opening, install the sunroof window screws without tightening them, then close the sunroof window from the vent position to the full closed position and adjust the sunroof window, finally tighten the sunroof window screws.

The recommended torque is 6 N.m (53 lb in).