2007 Chevrolet Equinox Fuse Box

You will need to turn the bolt counterclockwise to remove the connector from the component for connectors with a bolt in the dress cover, then locate the connector position assurance (CPA) on the top of the wire dress cover, then slide the lever lock forward while pressing down on the lever lock release tab, disconnect the connector from the component and locate the dress cover locking tabs at the corners of the dress cover, next remove the nose piece by inserting a small flat-blade tool into the slots on both ends of the connector body, release the terminals, and pull the wire out of the back of the connector while holding the removal tool in place.

You may need to install each of the following 68-way connectors into its proper location including fuse block case, forward lamp 68-way connector, engine 68-way connector, and I/P 68-way connector. Then you can push down on each connector until it is fully secured into the fuse block, connect the I/P connectors, tighten the bolts on the top of the fuse block, and tighten the underhood accessory wiring junction block harness retaining bolts to 4 N.m (35 lb in), next reconnect the positive battery cable and EPS at the end of the fuse block with the nut and tighten it to 17 N.m (13 lb-ft), finally install the fuse box cover and connect the negative battery cable.

The recommended torque is 17 N.m (13 lb-ft).

You will need the J-38125 Terminal Repair Kit.

The recommended torque is 2 N.m (18 lb in).