Part Description: 2007 Chevrolet Equinox Reservoir
More Info
Vehicle Fitment
2007 Chevrolet Equinox | LS, LT, LTZ, Sport | 6 Cyl 3.4 L GAS, 6 Cyl 3.6 L GAS
FAQ for Coolant Reservoir Repair
Q: How to install the Surge Tank Hose/Pipe-Inlet?
A:
You may need to install the surge tank inlet hose and the surge tank inlet hose clamp to the engine, then install the surge tank inlet hose and the surge tank inlet hose clamp to the surge tank.
By Bob
GM Specialist
01/11/2022
Q: How to remove the Surge Tank Hose/Pipe-Inlet?
A:
You will need to remove the surge tank inlet hose clamp and the surge tank inlet hose from the surge tank, then remove the surge tank inlet hose clamp and the surge tank inlet hose from the engine.
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the surge tank bolts tightened to the surge tank?
A:
The recommended torque is 9 N.m (80 lb in).
By Bob
GM Specialist
01/11/2022
Q: How to install the Surge Tank?
A:
You may need to install the heater outlet hose and the surge tank bolts to the surge tank, then connect the surge tank inlet hose to the surge tank, and install the surge tank inlet hose clamp, then fill the engine coolant.
By Bob
GM Specialist
01/11/2022
Q: How to remove the Surge Tank?
A:
You will need to drain the engine coolant, remove the surge tank inlet hose clamp from the surge tank, and remove the surge tank bolts from the surge tank, next remove the heater outlet hose clamp and the heater outlet hose from the surge tank, finally remove the surge tank.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How do you remove the Water Pump?
A:
You can drain the cooling system until the coolant is below the level of the Water Pump and release the tension on the drive belt, then remove the drive belt from the right idler pulley, and remove the J 39914 from the drive belt tensioner, next remove the following components: the water pump pulley bolts, the water pump pulley, the water pump bolts, the water pump, and the water pump gasket.
Q: How to install the Engine Coolant Fan Motor?
A:
You may need to install the engine Cooling Fan Motor, the cooling fan motor bolts, and the cooling fan motor nuts, tighten the nuts to 6 N.m (53 lb in), install the new engine cooling fan blade, turn the fan motor drive plate in the same direction of the arrow on the fan blade, rotate the cooling fan blade and install the fan shroud assembly.
Q: How to remove the Engine Coolant Thermostat Housing?
A:
You will need to remove the fuel injector sight shield, drain the coolant until the coolant level is below the thermostat, then remove the crossover exhaust pipe, remove the radiator hose from the Thermostat Housing, remove the thermostat housing bolts and clean any sealer from the bolt threads, then remove the thermostat housing and the thermostat.