< Back ×
My Vehicle Change Vehicle
2007 Chevrolet Equinox
< Back to View All
Driveline, Axles & 4WD
- Department
- Prices
OEM (Genuine) 2007 Chevrolet Equinox Cover Seal
PartNumber: 15864788
Product Specifications- Notes: All Wheel Drive, 2007-09
- Other Names: Cover Seal, Differential Cover Seal
- Item Dimensions: 7.5 x 7.5 x 0.2 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2007 Chevrolet Equinox Cover Seal
Vehicle Fitment- 2007 Chevrolet Equinox | L, LS, LT, LTZ, Premier, Sport | 4 Cyl 2.4 L FLEX, 4 Cyl 2.4 L GAS, 6 Cyl 3.0 L FLEX, 6 Cyl 3.0 L GAS, 6 Cyl 3.4 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
$10.68 MSRP:$17.66You Save: $6.98 (40%)
FAQ for Axle Shaft Seal Repair
Q: What tools are needed to replace the Rear Axle Shaft Seal-Left Side?
A:
You will need J 8092 Driver Handle and J 33832 Rear Bearing Installer.
By Bob
GM Specialist
28/10/2022Q: How to install the Drive Axle Shaft Seal (Right)?
A:
You may need to install the right drive axle seal onto the transaxle, install the transfer case for vehicles equipped with AWD, then install the right front wheel drive shaft, lower the vehicle and inspect the transaxle fluid level.
By Bob
GM Specialist
28/10/2022Q: How to install the Rear Axle Shaft Seal-Left Side?
A:
You may need to install the axle shaft seal, the left rear support bolt, the right differential support bushing nut, and the left differential mount, then install the left rear wheel drive shaft, the propeller shaft, and the exhaust system, remove the spare tire and fill the rear differential with fluid.
By Bob
GM Specialist
28/10/2022Q: How to install the Drive Axle Shaft Seal (Left)?
A:
You may need to install the left axle seal into the transaxle and the left front axle shaft, then lower the vehicle and inspect the transaxle fluid level.
By Bob
GM Specialist
28/10/2022Q: How to remove the Drive Axle Shaft Seal (Left)?
A:
You will need to place a drain pan under the transaxle to catch any spilled transaxle fluid, remove the left front axle shaft, then remove the axle seal from the transaxle and discard it, and finally clean the seal bore in the transaxle housing.
By Bob
GM Specialist
28/10/2022Q: How to remove the Drive Axle Shaft Seal (Right)?
A:
You will need to place a drain pan under the transaxle to catch any spilled transaxle fluid, then remove the right front wheel drive shaft, and remove the transfer case for vehicles equipped with all-wheel drive (AWD). If equipped with an axle seal dust cover, you should discard it and not replace it. Next, you can remove the right drive axle seal from the transaxle using the J 45000, and finally clean the seal bore in the transaxle housing.
By Bob
GM Specialist
28/10/2022See more FAQs (1)