Q: What's the recommended torque for the Supplemental Inflatable Restraint Front End Discriminating Sensor Bolt?
A:
The recommended torque is 8 N.m (71 lb in).
By Bob
GM Specialist
01/11/2022
Q: What's the tip for replacing the Inflatable Restraint Front End Discriminating Sensor Assembly?
A:
You may slide the sensor towards the front of the vehicle to guide the sensor bolt out of the release slot, and disconnect the electrical connector.
By Bob
GM Specialist
01/11/2022
Q: What's the preliminary procedure for replacing the Inflatable Restraint Side Impact Sensor?
A:
The procedure is to disable the SIR, then remove the center pillar lower molding.
By Bob
GM Specialist
01/11/2022
Q: What's the tip for replacing the Inflatable Restraint Vehicle Rollover Sensor Assembly?
A:
You may position the carpet to access the sensor, and disconnect the electrical connectors.
By Bob
GM Specialist
01/11/2022
Q: How many Inflatable Restraint Side Impact Sensor Bolts are needed?
A:
2Inflatable Restraint Side Impact Sensor Bolts attach.
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the Inflatable Restraint Side Impact Sensor Bolts?
A:
The recommended torque is 10 N.m (89 lb in).
By Bob
GM Specialist
01/11/2022
Q: How to disable the Negative Battery Cable?
A:
You will need to turn the steering wheel so that the vehicle's wheels are pointing straight ahead, place the ignition in the OFF position, disconnect the negative battery cable from the battery, then wait 1 minute before working on the system.
By Bob
GM Specialist
28/10/2022
See more FAQs (9)
FAQ for Other Repair Info
Q: How to remove the inflatable restraint steering wheel module coil?
A:
You will need to place the front wheels in the straight forward position with the steering wheel centered, disable the SIR system, then remove the inflatable restraint steering wheel module, remove the steering wheel and the steering column covers, then release the SIR coil harness clips from the bracket below the column. Finally, you can disconnect both the SIR coil horn/cruise connectors, carefully pry the retaining tabs away from the SIR coil assembly and slide the SIR coil assembly off the steering column using a small flat-bladed tool.