Part Description: 2007 Chevrolet Corvette Throttle Body
More Info
Vehicle Fitment
2007 Chevrolet Corvette | 427 Limited Edition Z06, Base, Z06 | 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS
FAQ for Throttle Body Repair
Q: What is the proper way to clean the Throttle Body?
A:
The proper way is to remove the air intake duct, inspect the throttle body bore and the throttle valve plate for deposits, clean the throttle body bore and the throttle valve plate, and install the air intake duct.
By Bob
GM Specialist
02/11/2022
Q: What should be learned about while servicing the throttle body?
A:
You shall cover or plug any openings to prevent possible contamination.
By Bob
GM Specialist
02/11/2022
Q: What should be noted when cleaning the Throttle Body?
A:
You shall turn OFF the ignition before inserting your fingers into the throttle bore.
By Bob
GM Specialist
02/11/2022
Q: What should be noticed while installing the throttle body?
A:
You shall ensure that the air control valve electrical connector and the connector seal are properly installed and not damaged.
By Bob
GM Specialist
02/11/2022
Q: What should be noticed while servicing the Throttle Learn?
A:
During the drive cycle, the check engine light may come on with idle speed DTCs. If idle speed codes are set, you shall clear codes so the ECM can continue to learn.
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: What should be done to remove the Air Cleaner Element?
A:
You shall remove the air cleaner assembly and the Air Filter.
Q: What is the installation procedure for the Manifold Absolute Pressure Sensor?
A:
The procedure is to install the MAP Sensor, reconnect the MAP sensor electrical connector, and install the engine sight shield.
Q: What should be noticed before installing the Intake Manifold?
A:
You must not use the Intake Manifold gaskets again and install NEW intake manifold-to-cylinder head gaskets.