2007 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
$12.96MSRP: $23.45
You Save: $10.49 (45%)
FAQ for Windshield Washer Hose Repair
Q: How to remove the hose-windshield washer?
A:
You need to remove the washer hose from the nozzles, remove the hose from the air inlet panel, disconnect the hose from the washer pump, then install a cap on the washer pump outlet to prevent excessive washer solvent loss, and remove the washer hose from the vehicle.
By Bob
GM Specialist
01/11/2022
Q: How to install the hose-windshield washer?
A:
You should position the new hose, remove the cap from the washer pump outlet and install the new hose to the outlet of the pump, position the hose to the air inlet panel, secure the hose to the air inlet grille panel, then connect the hose to the washer nozzles, install the air inlet grille panel, next top off the washer solvent container with washer solvent.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the washer pump?
A:
You should install the new Washer Pump grommet into the washer solvent container, then use clean washer solvent on the washer pump intake spout to aid in the installation of the new washer pump, and apply downward pressure onto the pump to seat the pump to the grommet, next secure the top of the pump to the washer container, finally install the washer solvent container.
Q: How to install the Wiper Arm Blade?
A:
You should position the Wiper Blade in the inside radius of the wiper arm hook, insert the hook of the wiper arm through the opening in the wiper blade, pull upward until the locking tab of the pivot engages the slot in the hook, then lower the wiper arm and blade onto the windshield.
Q: How to remove the washer solvent container?
A:
You need to remove the air cleaner assembly, the washer container to fender flange fasteners, the coolant reservoir to the wheelhouse fastener, disconnect the electrical connector from the washer pump, then remove the bolt securing the washer container to the top bracket, remove the bolt securing the washer/coolant reservoir to the J-clip, and position the coolant reservoir off to the side, remove the washer hose from the washer pump, drain the washer solvent into a suitable container, then remove the washer solvent container, remove the pump, grommet, cap, and lower container grommet, finally discard the washer solvent container.