< Back ×
My Vehicle Change Vehicle
2007 Chevrolet Colorado
< Back to View All
Ignition, Distributors & ECM
- Department
- Prices
OEM (Genuine) 2007 Chevrolet Colorado Cylinder & Keys
PartNumber: 89022365
Product Specifications- Notes: W/Tilt
- Other Names: Cylinder & Keys, Ignition Lock Cylinder
- Item Dimensions: 5.8 x 4.6 x 1.7 inches
- Item Weight: 0.60 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2007 Chevrolet Colorado Cylinder & Keys
Vehicle Fitment- 2007 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
$29.91 MSRP:$49.53You Save: $19.62 (40%)
FAQ for Ignition Lock Cylinder Repair
Q: What kind of special tools will be required in the Assembling and Coding Ignition Lock Cylinders?
A:
The tools required include J41340 Ignition Lock Holding Fixture.
By Bob
GM Specialist
01/11/2022Q: How to install the Ignition Lock Cylinder?
A:
First, you should turn the ignition lock cylinder to the accessory (ACC) position, then push the lock cylinder in until the pin locks in the lock module, next install the steering column trim covers.
By Bob
GM Specialist
01/11/2022Q: How to remove the Ignition Lock Cylinder?
A:
You need to remove the steering column trim covers, next turn the ignition lock cylinder to the accessory (ACC) position, then insert the 90 degrees tip of a pick-type tool into the access hole of the ignition lock cylinder, push down and hold the retaining pin of the ignition lock cylinder, finally remove the ignition lock cylinder.
By Bob
GM Specialist
01/11/2022Q: How to inspect for proper tumbler installation?
A:
You need to hold the spring retainer in position, then insert the key into the cylinder, and the sidebar should drop down flush with the cylinder diameter if installed, finally disassemble and assemble properly as needed.
By Bob
GM Specialist
01/11/2022Q: How to remove the Ignition Lock Cylinder Case?
A:
You need to disable the SIR system, remove the lock cylinder, the switch mounting plate, and the shear bolt from the ignition switch and lock housing assembly using a hammer and chisel, then remove the ignition switch and lock housing assembly.
By Bob
GM Specialist
01/11/2022Q: How to install the Ignition Lock Cylinder Case?
A:
You should install the ignition switch and lock housing assembly, install the shear bolt into the ignition switch and lock housing assembly, install the switch mounting plate and the lock cylinder, then reprogram the theft deterrent system, and enable the SIR system.
By Bob
GM Specialist
01/11/2022See more FAQs (1)