2007 Chevrolet Colorado Air Bag Sensor

You should position the inflatable restraint module to the steering wheel, connect the electrical connectors to the inflatable restraint steering wheel module, connect the horn electrical connector, then position the 4 alignment posts of the inflatable restraint module to the holes that are located on the steering wheel housing, push the inflatable restraint module into the steering wheel to engage and latch the leaf spring fasteners. After installation, you need to pull up on the sides of the inflatable restraint module and enable the inflatable restraint steering wheel module.

You need to install the PSIR bracket to the I/P structure if replacing the PSIR bracket, then install the 2 fasteners retaining the PSIR bracket to the I/P structure, install the I/P assembly, next position the PSIR inflator module to the front of the I/P and connect the electrical connector, connect the CPA, and install the PSIR inflator module to the I/P. then you should install the 2 lower fasteners retaining the PSIR module to the I/P structure, install the 2 side retaining nuts to the PSIR inflator module, install the digital radio receiver and the radio, the I/P accessory trim panel, the right air outlet, the right access cover to the I/P end cap, then enable the SIR System, and install the I/P compartment door.

First, you need to place the J39401-B in the center of the cleared area, next fill the deployment fixture with water or sand to provide sufficient stabilization of the fixture during deployment, then adjust and secure the fixture arms to the deployment fixture, using the proper nuts and bolts, finally attach the roof rail module in the deployment fixture and securely tighten all fasteners.

The recommended torque is 9 N.m (79 lb in).

You need to install the 3 bolts retaining the roof rail airbag module to the roof, install the forward curtain clip, the bolt retaining the bracket to the roof, the 3 bolts retaining the rear curtain to the roof, then install the clips to the pillar, the roof rail airbag forward tether bolt, connect the roof rail airbag electrical connector, install the headliner, and enable the SIR system, and install the head restraints from the front seats.