2007 Chevrolet Cobalt | Base, LS, LT, LTZ, Sport, SS | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L GAS
FAQ for Trunk Lid Latch Repair
Q: What is the proper way to install the rear compartment lid latch striker?
A:
The proper way is to position the lock striker to the alignment marks, install and hand tighten the striker and bolts, inspect the striker alignment, and then tighten the lock striker bolts.
By Bob
GM Specialist
01/11/2022
Q: How many bolts does the rear compartment latch have?
A:
The rear compartment latch has 2 bolts.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the bolts?
A:
The recommended torque is 10 Nm (89 LB in).
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the rear compartment lid latch striker?
A:
The procedure is to mark around the striker with a grease pen to retain the position of the lock striker and then remove the lock striker bolts and the lock striker.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the hood latch?
A:
The proper way is to install the Hood Latch release cable, position the hood latch, install the hood latch bolts, close the hood and press down, and then adjust the hood.
Q: What is the proper way to install the hood latch release cable?
A:
The proper way is to tape the feeder wire, install the hood primary latch release cable, the Hood Release Cable handle assembly, and the front carpet retainer, and then inspect the hood latch cable for proper operation.
Q: What is the removal procedure for the washer pump?
A:
The procedure is to remove the front fender liner, the Washer Pump, and the seal.