2007 Chevrolet Cobalt CV Joint Boot

The procedure is to remove and discard the small seal clamp, the large seal retaining clamp, the tripot housing, the retaining ring, and the seal, and then inspect the tripot joint components for unusual wear, cracks, and other damage.

The procedure is to clamp the drive axle shaft, remove the small seal clamp, the CV joint retaining ring, the first bearing roller, and the inner race, inspect the CV joint assembly, and then clean the wheel drive shaft bar.

You should follow the instructions provided because the disassembly and assembly of the joints will be difficult due to the helical splines on the shaft.

The procedure is to install the small seal clamp, measure the clamp gap width, install the tripot spider assembly, the retaining ring, the large clamp, and the tripot housing, and then rotate the housing in a circular motion to distribute the grease in the tripot joint.

The proper way is to install the new small seal clamp, the First, bearing roller, the CV joint retaining ring, the large seal retaining clamp, and the gap dimension.