Notes: Not legal for use in Calif; Illegal for installation in NY on vehicles equipped w/Calif emission systems; w/1 converter;Not legal for use in Calif; Illegal for installation in NY on vehicles equipped w/Calif emission systems; Fed Emissions; w/1 converter
Catalytic Converter Overall Length: 36.5"
Converter Configuration: Direct Fit
Inlet Type: 3 Bolt Fixed Flange
O2 Sensor Port: Yes
Outlet Type: 2 Bolt Fixed Flange
Position: Center
UPC: 841809119490
Part Description: 2007 Chevrolet Cobalt Direct Fit Catalytic Converter and Pipe Assembly
Notes: 2.2 Liter, Auto Trans, Federal; Cobalt; 2.2l; Auto Trans; Federal
Other Names: Catalytic Converter, Converter & Pipe
Item Dimensions: 42.0 x 16.8 x 10.2 inches
Item Weight: 16.40 Pounds
Fitment Type: Direct Replacement
Replaces: 15873732, 15247470, 22703214
Part Description: 2007 Chevrolet Cobalt 3Way Catalytic Convertor Assembly (W/Exhaust Manifold Pip
More Info
Vehicle Fitment
2007 Chevrolet Cobalt | Base, LS, LT, LTZ | 4 Cyl 2.2 L GAS
FAQ for Catalytic Converter Repair
Q: What is the removal procedure for the catalytic converter (RPO LSJ)?
A:
The procedure is to remove the HO2S, the catalytic converter, the catalytic converter pipe, the catalytic converter, and the exhaust gaskets.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the catalytic converter (RPO LSJ)?
A:
The proper way is to install a new gasket, the catalytic converter, the catalytic converter pipe, the HO2S, and the HO2S CPA retainer.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the engine oil and oil filter?
A:
The proper way is to install the filter, the Oil Filter cap, the oil filter, and the oil pan drain plug, and then fill the engine with oil.
Q: What is the proper way to install the heated oxygen sensor 1?
A:
The proper way is to coat the threads of the Oxygen Sensor, install the oxygen sensor, connect the oxygen sensor harness connector, and then install the exhaust manifold heat shield.
Q: What is the procedure for cleaning the throttle body?
A:
The procedure is to remove the Throttle Body, open the throttle valve, remove dirt or carbon deposits/buildup, and then inspect that the throttle valve operates smoothly and freely.