FAQ for Battery Cables Repair
Q: What is the proper way to install the battery negative cable (Battery to Battery Tray)?
A:
The proper way is to install the negative battery cable, and the negative battery cable ground bolt, and then connect the body harness electrical connector and the negative battery cable.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the battery positive cable (Battery to Underhood Junction Block)?
A:
The proper way is to lay out the positive battery cable assembly, route the positive battery cable, and install the positive battery cable, the junction block nut, the junction block cover, and the carpet.
By BobGM Specialist
01/11/2022 Q: What is important for the battery positive cable replacement?
A:
You should always use replacement cables that are of the same type, diameter, and length of the cables that you are replacing, and always route the replacement cable the same way as the original cable.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the battery negative cable (Battery to Battery Tray)?
A:
The procedure is to disconnect the negative battery cable and the body harness electrical connector and remove the negative battery cable ground bolt and the negative battery cable.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the battery negative cable (Engine to Chassis)?
A:
The procedure is to remove the engine harness ground terminal, the negative battery cable ground terminal, the stud, the negative battery cable ground nut, the old tape, and the negative battery cable.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the battery negative cable (Engine to Chassis)?
A:
The proper way is to install the negative battery cable, the negative battery cable ground terminal, the battery cable ground nut, the engine harness grounds, and the engine harness ground terminal, and then connect the negative battery cable.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the battery-positive cable (Battery to Underhood Junction Block)?
A:
The procedure is to remove the positive battery cables from the battery, the body clip, the body wiring harness clips, and the body wiring harness clips, and then remove the junction block nut and the positive battery cable (to the starter) terminal.
By BobGM Specialist
01/11/2022 See more FAQs (2)