< Back ×
My Vehicle Change Vehicle
2007 Chevrolet Cobalt
< Back to View All
ABS & Parking Brake
- Department
- Prices
OEM (Genuine) 2007 Chevrolet Cobalt Modulator
PartNumber: 15870922
Product Specifications- Other Names: Control Module, Modulator
- Item Dimensions: 7.1 x 6.1 x 5.1 inches
- Item Weight: 1.20 Pounds
- Fitment Type: Direct Replacement
- Replaces: 15233333
- Part Description: 2007 Chevrolet Cobalt Modulator
Vehicle Fitment- 2007 Chevrolet Cobalt | LS, LT, LTZ, SS | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L GAS
OEM (Genuine) 2007 Chevrolet Cobalt Brake Pressure Modulator Valve Assembly
PartNumber: 19212185
Product Specifications- Notes: Cobalt; W/O Rear Disc Brakes;Cobalt; W/Rear Disc Brakes
- Other Names: Modulator, Modulator Valve
- Item Dimensions: 8.4 x 6.2 x 6.3 inches
- Item Weight: 5.50 Pounds
- Fitment Type: Direct Replacement
- Replaces: 15295449, 15239967
- Part Description: 2007 Chevrolet Cobalt Brake Pressure Modulator Valve Assembly
Vehicle Fitment- 2007 Chevrolet Cobalt | Base, LS, LT, LTZ, SS | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L GAS
OEM (Genuine) 2007 Chevrolet Cobalt Modulator
PartNumber: 19301490
Product Specifications- Notes: All
- Item Dimensions: 8.4 x 8.2 x 7.2 inches
- Item Weight: 13.10 Pounds
- Fitment Type: Direct Replacement
- Replaces: 10386648, 15868931
- Part Description: 2007 Chevrolet Cobalt Modulator
Vehicle Fitment- 2007 Chevrolet Cobalt | Base, LS, LT, LTZ, Sport, SS | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L GAS
FAQ for Abs Control Module Repair
Q: What is the proper way to install the electronic brake control module?
A:
The proper way is to clean the EBCM mating surface, install the EBCM to the BPMV, connect the electrical connector, turn the ignition switch to the ON position, perform the Diagnostic System Check-Vehicle, and then refer to Control Module References for programming and setup information.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the electronic brake control module?
A:
The procedure is to turn the ignition switch to the OFF position, remove the throttle body air snorkel, clean the electronic brake control module, remove the 4 EBCM-to-BPMV retaining bolts, disconnect the electrical connector, and then separate the EBCM from the BPMV.
By Bob
GM Specialist
01/11/2022