FAQ for Brake Hose Repair
Q: What can be used to cut the brake pipe squarely to the measured length?
A:
You can use the pipe cutter included in the J 45405.
By BobGM Specialist
01/11/2022 Q: What can be used to disconnect the brake pipe fitting from the brake hose, then cap or plug the brake pipe fitting end?
A:
You can use a backup wrench on the hose fitting.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the rear brake hose?
A:
The procedure is to remove the rear tire and wheel assembly, remove the brake hose retainer, remove the brake hose from the bracket, remove the brake caliper inlet fitting bolt, remove the brake hose from the brake caliper and remove the two copper brake hose gaskets.
By BobGM Specialist
01/11/2022 Q: What is the purpose of installing a rubber cap or plug to the exposed brake pipe fitting end?
A:
The purpose is to prevent brake fluid loss and contamination.
By BobGM Specialist
01/11/2022 Q: What should you use when replacing brake pipes?
A:
You can always use a double-walled steel brake pipe.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when connecting the brake pipe fitting to the brake hose?
A:
You can tighten the brake pipe fitting to 18 N.m (13 lb-ft).
By BobGM Specialist
01/11/2022 Q: How do you install the rear brake hose?
A:
You can assemble the new copper brake hose gaskets and the brake caliper inlet fitting bolt to the brake hose, install the brake hose and the brake caliper inlet fitting bolt to the brake caliper, install the brake hose to the hose bracket, install the retainer onto the brake hose fitting and install the tire and wheel assembly.
By BobGM Specialist
01/11/2022 See more FAQs (2)