FAQ for Brake Caliper Repair
Q: What is the recommended torque for the brake caliper bleeder valve?
A:
The recommended torque is 14 N.m (124 lb in).
By BobGM Specialist
29/10/2022 Q: Can you use abrasives to clean the brake caliper pistons?
A:
No, do not use abrasives to clean the brake caliper pistons.
By BobGM Specialist
29/10/2022 Q: How long should be left for the thread locker to cure before installation?
A:
Allow the thread locker to cure approximately 10 minutes before installation.
By BobGM Specialist
29/10/2022 Q: What is the recommended torque for the front brake caliper bracket bolts?
A:
The recommended torque is 130 N.m (96 lb-ft).
By BobGM Specialist
29/10/2022 Q: What is the recommended torque for the brake caliper bolt?
A:
The recommended torque is 50 N.m (37 lb-ft).
By BobGM Specialist
29/10/2022 Q: What is the recommended torque for the brake caliper pin bolts?
A:
The recommended torque is 60 N.m (44 lb-ft).
By BobGM Specialist
29/10/2022 Q: Can you reuse the copper brake hose gaskets?
A:
No, you need to install NEW copper brake hose gaskets.
By BobGM Specialist
29/10/2022 Q: What should be noted if reusing the caliper bracket bolts?
A:
The threads of the caliper bracket bolts and the threads of the knuckle mounting holes must be free of residue and debris before applying the thread locker, to ensure proper adhesion and fastener retention.
By BobGM Specialist
29/10/2022 Q: What kind of special tools will be used when removing the Rear Brake Caliper Overhaul (JE5)?
A:
J8092 Universal Driver, J 46275 Caliper Boot Seal Installer.
By BobGM Specialist
29/10/2022 Q: What should you do when the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level?
A:
In this situation, you need to remove brake fluid to the midway point before proceeding.
By BobGM Specialist
29/10/2022 See more FAQs (9)