FAQ for Air Bag Sensor Repair
Q: What kind of special tools will be used when removing the Air Bag Sensor?
A:
J38826 SIR Deployment Harness, J 39401-B SIR Deployment Fixture, J 38826-25 Roof rail module adapter, J 38826-50 Side impact module adapter, J 38826-75 Steering wheel module adapter (dual stage airbags), J 38826-80 I/P module adapter (dual stage airbags).
By BobGM Specialist
01/11/2022 Q: How do you install the Inflatable Restraint Side Impact Module Wiring Harness?
A:
You need to install the new side impact module wiring harness, the retaining clips, the side impact module, and the seat back panel.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the Inflatable Restraint Side Impact Module Wiring Harness?
A:
Disable the SIR system, partially remove the seat back panel, remove the inflatable restraint side impact module, and the retaining clips.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the bracket mounting bolts?
A:
The recommended torque is 9 N.m (80 lb in).
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the I/P module mounting fasteners?
A:
The recommended torque is 9 N.m (80 lb in).
By BobGM Specialist
01/11/2022 Q: What should you notice in the installation of the Inflatable Restraint Roof Rail Module-Left Side?
A:
Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened.
By BobGM Specialist
01/11/2022 Q: What can you do to help in assembly?
A:
You can note the wire harness routing position on the I/P module in the removal.
By BobGM Specialist
01/11/2022 Q: What should you care about when disconnecting the wiring harness connector from the front-end sensor?
A:
You need to notice that the front-end sensor mounting fastener has left-handed threads.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the mounting fasteners?
A:
The recommended torque is 9 N.m (80 lb in).
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the Inflatable Restraint Side Impact Sensor?
A:
First, disable the SIR system. second, move the seat to the full forward position. next, remove the center pillar trim panel, the connector position assurance (CPA). then, disconnect the harness connector from the SIS. and, remove the SIS mounting fasteners, and the SIS.
By BobGM Specialist
01/11/2022 See more FAQs (9)