2007 Cadillac Escalade ESV TPMS Sensor

You need to remove the tire/wheel assembly from the vehicle, dismount the tire from the rim, remove the TORX screw from the tire pressure sensor and pull it straight off the tire pressure valve stem and the tire pressure valve stem by pulling it through the rim.

You need to apply tire soap to the rubber portion of the valve stem, use a tire valve stem mounting tool to pull the valve stem through in a direction parallel to the valve hole on the rim, mount the tire to the rim, install the tire/wheel assembly on the vehicle, lower the vehicle and learn the tire pressure sensors.

You need to clean any dirt or debris from the grommet sealing area, insert the sensor in the wheel hole with the air passage facing away from the wheel, install the sensor nut and position the sensor body parallel to the inside wheel surface while torquing, the tire on the wheel and the tire/wheel assembly on the vehicle and learn the tire pressure sensors.

You need to remove the tire/wheel assembly from the vehicle, the tire from the wheel, the tire pressure sensor nut, and the tire pressure sensor.

You need to install a scan tool, turn ON the ignition, with the engine OFF, select module setups, remote control door lock receiver, tire type/pressure selection, p-metric standard, and the front tire pressure as noted on the vehicle drivers door placard sticker and the rear tire pressure as noted on the vehicle drivers door placard sticker and verify the selections made are correct and press the enter key. The scan tool will flash the procedure in progress, then display the procedure completely, and then press the exit key to escape.