Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2007 Cadillac Escalade ESV Ring And Pinion

2007 Cadillac Escalade ESV Ring And Pinion

My Vehicle Change Vehicle
2007 Cadillac Escalade ESV
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Driveline, Axles & 4WD
  • Department
  • Brands
  • Prices

10 Products found

2 Q&A for Ring And Pinion Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for Ring And Pinion Repair

Q: How do you install the drive pinion and ring gear?
A:
You need to install the ring gear and the new ring gear bolts and tighten the ring gear bolts and the ring gear bolts alternately and in stages, gradually pulling the ring gear onto the differential case.
By Bob
GM Specialist
01/11/2022
Q: How do you remove the drive pinion and ring gear?
A:
You need to remove the differential assembly and the pinion yoke and the oil seal, install the J 22536 as shown, drive the pinion out using the J 22536 and a hammer, strike the J 22536 slowly, and remove the collapsible spacer from the pinion, discard the spacer and remove the pinion bearings and the cups, the ring gear bolts and the ring gear from the differential and drive the gear off with a brass drift if necessary.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How do you remove the Rear Axle Shaft (8.6, 9.5 LD Axle)?
A:
You need to remove the tire and wheel assembly, the brake caliper, the rear wheel speed sensor, the rear cover, the gasket, and the pinion shaft locking bolt. On axles without a locking differential, remove the pinion shaft. On axles with a locking differential, remove the shaft partway. On axles with a locking differential, use a screwdriver, or a similar tool, to enter the differential case and rotate the lock until the lock aligns with the thrust block. Then you can push the flange of the Axle Shaft toward the differential, and remove the C-lock from the button end of the axle shaft and the axle shaft from the housing.
Q: What should you align when positioning the CV joint end (outboard end) of the half shaft assembly in the bottom half of J 36652-1 or J 36652-2?
A:
You need to align the CV Joint Boot, the CV joint assembly, and the swaging ring.
Q: How do you remove the front axle lubricant?
A:
You need to remove the front Differential carrier shield, clean the area around the front axle fill plug and the drain plug, remove the fill plug and the drain plug, and drain the fluid from the front differential carrier assembly.