Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2007 Cadillac Escalade ESV Differential Seal

2007 Cadillac Escalade ESV Differential Seal

My Vehicle Change Vehicle
2007 Cadillac Escalade ESV
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Driveline, Axles & 4WD
  • Department
  • Brands
  • Prices

3 Products found

3 Q&A for Differential Seal Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for Differential Seal Repair

Q: How to install the oil seal?
A:
You need to position the oil seal over the seal bore, install the J 36366 over the oil seal and strike the J 36366 with a hammer until the seal flange seats on the axle housing surface.
By Bob
GM Specialist
29/10/2022
Q: What special tools will I be needing when replacing the Front Differential Drive Pinion Flange/Yoke, Seal, and Dust Deflector?
A:
You will be needing a flange and pulley holding tool and a pinion oil seal installer.
By Bob
GM Specialist
29/10/2022
Q: What is the recommended torque for the yoke retainer bolts?
A:
The recommended torque is 25 N.m (18 Ib ft).
By Bob
GM Specialist
29/10/2022

FAQ for Other Repair Info

Q: How do you remove the Rear Axle Shaft (8.6, 9.5 LD Axle)?
A:
You need to remove the tire and wheel assembly, the brake caliper, the rear wheel speed sensor, the rear cover, the gasket, and the pinion shaft locking bolt. On axles without a locking differential, remove the pinion shaft. On axles with a locking differential, remove the shaft partway. On axles with a locking differential, use a screwdriver, or a similar tool, to enter the differential case and rotate the lock until the lock aligns with the thrust block. Then you can push the flange of the Axle Shaft toward the differential, and remove the C-lock from the button end of the axle shaft and the axle shaft from the housing.
Q: What should you align when positioning the CV joint end (outboard end) of the half shaft assembly in the bottom half of J 36652-1 or J 36652-2?
A:
You need to align the CV Joint Boot, the CV joint assembly, and the swaging ring.
Q: How do you remove the front axle lubricant?
A:
You need to remove the front Differential carrier shield, clean the area around the front axle fill plug and the drain plug, remove the fill plug and the drain plug, and drain the fluid from the front differential carrier assembly.