Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2007 Cadillac Escalade ESV 4WD Switch

2007 Cadillac Escalade ESV 4WD Switch

My Vehicle Change Vehicle
2007 Cadillac Escalade ESV
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Driveline, Axles & 4WD
  • Department
  • Brands
  • Prices

1 Product found

2 Q&A for 4WD Switch Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by
  • Dorman OE Solutions 4Wd Switch for 2007 Cadillac Escalade ESV - 901-072

    Dorman® OE Solutions 4Wd Switch for 2007 Cadillac Escalade ESV

    PartNumber: 901-072
    Product Specifications
    • Notes: w/RPO Code NP8 (2Spd, Push Button Shift, Transfer Case)
    • Attached Lead Wires: No
    • Mounting Location: Dash
    • OE Part Number: 15136039, 15164520, 19259313
    • Package Contents: 1 Switch
    • Terminal Type: 12 Pins
    • UPC: 019495387114
    • Wiring Harness Included: No
    • Part Description: OE Solutions 4Wd Switch
    More Info
    $33.62

FAQ for 4WD Switch Repair

Q: What should be noticed when replacing the Switch, Transfer Case Control?
A:
You need to disconnect the electrical connectors from the headlight and control switches. It may be necessary to use a small flat-bladed screwdriver to depress the locking tabs to remove the control switch.
By Bob
GM Specialist
01/11/2022
Q: What should you do before replacing the Transfer Case Shift Control Switch?
A:
You need to remove the headlight bezel.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How do you remove the Rear Axle Shaft (8.6, 9.5 LD Axle)?
A:
You need to remove the tire and wheel assembly, the brake caliper, the rear wheel speed sensor, the rear cover, the gasket, and the pinion shaft locking bolt. On axles without a locking differential, remove the pinion shaft. On axles with a locking differential, remove the shaft partway. On axles with a locking differential, use a screwdriver, or a similar tool, to enter the differential case and rotate the lock until the lock aligns with the thrust block. Then you can push the flange of the Axle Shaft toward the differential, and remove the C-lock from the button end of the axle shaft and the axle shaft from the housing.
Q: What should you align when positioning the CV joint end (outboard end) of the half shaft assembly in the bottom half of J 36652-1 or J 36652-2?
A:
You need to align the CV Joint Boot, the CV joint assembly, and the swaging ring.
Q: How do you remove the front axle lubricant?
A:
You need to remove the front Differential carrier shield, clean the area around the front axle fill plug and the drain plug, remove the fill plug and the drain plug, and drain the fluid from the front differential carrier assembly.