< Back ×
My Vehicle Change Vehicle
2007 Cadillac DTS
< Back to View All
Wipers & Washers
- Department
- Prices
OEM (Genuine) 2007 Cadillac DTS Indicator
PartNumber: 25864383
Product Specifications- Item Dimensions: 3.4 x 2.2 x 1.7 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Replaces: 22110978, 15809926
- Part Description: 2007 Cadillac DTS Indicator
Vehicle Fitment- 2007 Cadillac DTS | Base, Livery, Luxury, Platinum, Premium | 8 Cyl 4.6 L GAS
$31.36 MSRP:$59.17You Save: $27.81 (48%)
FAQ for Washer Fluid Level Sensors Repair
Q: What is the removal procedure for the fuse?
A:
The procedure is to disconnect the negative battery cable, locate the underhood bussed electrical center, remove the UBEC cover and the 60 amp heated windshield washer fuse, connect the negative battery cable, test the operation of the windshield wiper system, close the hood, and then make a copy of the Owner Manual Supplement, located at the back of this bulletin, and place it in the glove box.
By Bob
GM Specialist
02/11/2022Q: How many nuts does the washer solvent heater have?
A:
The washer solvent heater has 2 nuts.
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the washer solvent heater nuts?
A:
The recommended torque is 9 Nm (80 LB in).
By Bob
GM Specialist
02/11/2022Q: What should be done before replacing the Washer Solvent Container Level Sensor?
A:
You should remove the right front wheelhouse panel liner, drain the washer solvent into a suitable clean container, and disconnect the electrical connector at the windshield washer level sensor switch.
By Bob
GM Specialist
02/11/2022Q: What will happen with the short circuit on the printed circuit board for the washer fluid heater?
A:
Ashort circuit on the printed circuit board for the washer fluid heater may overheat the control-circuit ground wire. This may cause other electrical malfunctions, create an odor, or cause smoke. In rare cases, it may cause a fire.
By Bob
GM Specialist
02/11/2022Q: What should be done before replacing the Windshield Washer Solvent Heater?
A:
You should open the hood and disconnect the 2 electrical connectors for the washer solvent heater.
By Bob
GM Specialist
02/11/2022Q: Why is your vehicle being recalled?
A:
It is because of a new failure mode attributed to the device's thermal protection feature. Their significance varies from minor distortion to considerable melting of the plastic around the HWFS fluid chamber. In some circumstances, the heated washer module can cause a fire.
By Bob
GM Specialist
02/11/2022Q: What will happen with a printed circuit board electrical short within the Heated Washer Fluid System (HWFS).?
A:
The significance of this failure can vary from minor distortion to considerable melting of the plastic around the HWFS fluid chamber. In some circumstances, the heated washer module can cause a fire.
By Bob
GM Specialist
02/11/2022Q: What should you do?
A:
You should contact your GM dealer/retailer to arrange a service appointment as soon as possible.
By Bob
GM Specialist
02/11/2022Q: What should be done if a customer refuses to have this safety recall performed on their vehicle?
A:
Dealers are to provide the customer with a copy of the °Notice to Customer° document provided in this bulletin, record on the repair order °customer declined recall repair° and, if possible, have the customer sign the repair order.
By Bob
GM Specialist
02/11/2022See more FAQs (12)