Part Description: 2007 Cadillac DTS Block Asm-Engine Wiring Harness Junction
More Info
Vehicle Fitment
2007 Cadillac DTS | Base, Luxury | 8 Cyl 4.6 L GAS
FAQ for Fuse Box Repair
Q: What is the removal procedure for the Underhood Electrical Center or Junction Block?
A:
The procedure is to remove the electrical center cover, disconnect the positive battery cable from the junction box, remove the unlock the tabs, and then remove the fasteners securing the electrical center to the vehicle.
By Bob
GM Specialist
01/11/2022
Q: How to Identify These Fuses?
A:
Packed in a 120-piece set, the fuse has a translucent, hard plastic, blue body with the amperage stamped into the top. There are no white painted numbers on the fuse to indicate amperage. There are no identifying marks on the fuse to tell who is making it.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the Underhood Electrical Center or Junction Block?
A:
The proper way is to install fasteners securing the electrical center to the vehicle, the harness, and the electrical center cover.
By Bob
GM Specialist
01/11/2022
Q: What is the Aftermarket Fuse Warning?
A:
General Motors has become aware of a fuse recall by Harbor Freight Tools/Storehouse for a variety of aftermarket fuses. In two cases, these fuses have not protected the wiring system of the vehicles they were customer installed in. Upon testing the 15 amp version, it was found that the fuse still would not °open° when shorted directly across the battery terminals.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the Starter Motor?
A:
The proper way is to install the Starter motor, the starter solenoid cable, the °S° terminal nut, the °BAT° terminal nut, and the intake manifold, and then connect the negative battery cable.
Q: What is the proper way to install the Sunroof Motor/Actuator?
A:
The proper way is to install the Sunroof Motor/actuator and the bolts, connect the electrical connectors, check the sunroof window, and then install the headliner.
Q: What should be done before replacing the Park/Turn Signal Lamp Bulb?
A:
You should remove the high-intensity discharge lamp assembly.