2007 Cadillac DTS | Base, Luxury, Platinum | 8 Cyl 4.6 L GAS
$285.87MSRP: $538.40
You Save: $252.53 (47%)
FAQ for Engine Control Module Repair
Q: What should be noticed about the Powertrain Control Module and Electrostatic Discharge?
A:
Do not touch the connector pins or soldered components on the circuit board.
By Bob
GM Specialist
01/11/2022
Q: What should be known when a dealer is performing a repair under the New Vehicle Limited Warranty?
A:
When a dealer is performing a repair under the New Vehicle Limited Warranty, they are required to use only genuine GM or GM-approved parts and accessories. This applies to all warranty repairs, special policy repairs, or any repairs paid for by GM.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the Engine Control Module?
A:
The procedure is to disconnect the negative battery cable and the engine harness electrical connector, and then remove the air cleaner outlet duct, the air cleaner upper housing, the engine harness electrical connectors, and the ECM.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed about the engine's horsepower and torque?
A:
General Motors does not support or endorse the use of devices or modifications that, when installed, increase the engine horsepower and torque.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the Engine Control Module?
A:
The proper way is to install the ECM to the lower air cleaner housing, install the engine harness electrical connectors, the air cleaner upper housing, and the air cleaner outlet duct. And then program the ECM. Refer to Control Module References.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the Bank 1 Ignition Coil?
A:
The proper way is to install the Ignition Coil assembly, the fuel injector sight shield studs, the ignition coil, the individual ignition coil bolt, and both of the fuel injector sight shields.
Q: What is the proper way to install the Knock Sensor?
A:
The proper way is to install the appropriate Knock Sensor, connect the electrical connector, and then install the intake manifold.