Part Description: 2007 Cadillac DTS Module Asm-Cruise Control (W/ Vehicle Dist Sensor)
More Info
Vehicle Fitment
2007 Cadillac DTS | Base, Luxury, Platinum | 8 Cyl 4.6 L GAS
FAQ for Cruise Control Module Repair
Q: What should be done to assure proper alignment of the DSCC?
A:
To assure proper alignment of the DSCC, the vehicle must be aligned to the reference line.
By Bob
GM Specialist
01/11/2022
Q: What is the procedure for the Distance Sensing Cruise Control Maintenance?
A:
The procedure is to remove the distance sensing cruise control (DSCC) module cover, clean the surfaces of the inner and outer DSCC module cover, and the outer surface of the DSCC module, and then install the DSCC module cover to the fascia grille.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the cruise control module assembly?
A:
The recommended torque is 9 Nm (80 LB in).
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the cruise control module assembly?
A:
The recommended torque is 9 Nm (80 LB in).
By Bob
GM Specialist
01/11/2022
Q: What is the DSCC Aiming Set-Up Procedure?
A:
The procedure is to paint a 51 mm (2 in) vertical reference line on the wall, paint a 51 mm (2 in) reference line at a 90-degree right angle on the floor, place a temporary mark on the floor, measure 2.4 m (8 ft) straight back from the vertical reference line, and then paint a 51 mm (2 in) circle on the wall to be used as a target.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the Starter Motor?
A:
The proper way is to install the Starter motor, the starter solenoid cable, the °S° terminal nut, the °BAT° terminal nut, and the intake manifold, and then connect the negative battery cable.
Q: What is the proper way to install the Sunroof Motor/Actuator?
A:
The proper way is to install the Sunroof Motor/actuator and the bolts, connect the electrical connectors, check the sunroof window, and then install the headliner.
Q: What should be done before replacing the Park/Turn Signal Lamp Bulb?
A:
You should remove the high-intensity discharge lamp assembly.