2007 Buick Rendezvous Ignition Coil

After disconnecting the battery negative cable and removing the steering wheel, you need to remove the retaining screw, tilt the trim cover down and slide rearward, and remove the retaining screws. Then you can lift the trim cover, insert the Snap-On A173A bent-tip awl into the access hole of the Ignition Lock Cylinder, turn the ignition lock cylinder to start, and push down on the ignition lock cylinder retainer. After that, you can release the ignition lock cylinder to the run position and remove the ignition lock cylinder from the lock cylinder case.

After installing the Knock Sensor, you can connect the engine harness electrical connector and lower the vehicle.

After retrieving the percentage of remaining engine oil, you can disconnect the negative battery cable. Then you need to remove the left diagonal brace and the air cleaner assembly cover. After lifting the powertrain control module (PCM), you can disconnect the engine harness electrical connectors and remove the PCM.