Part Description: 2007 Buick Rendezvous Panel Air Element
Vehicle Fitment
2007 Buick Rendezvous | All Trims | 6 Cyl 3.5L
FAQ for Air Filter Repair
Q: How to install the automatic level control air compressor air filter?
A:
You need to install the automatic level control air compressor filter and the automatic level control air compressor filter. Then you can lower the vehicle.
By Bob
GM Specialist
01/11/2022
Q: How to remove the automatic level control air compressor air filter?
A:
After raising and supporting the vehicle, you can squeeze the clips on side of the filter. Then you need to pull the filter out of the hole in the rail and remove the automatic level control air compressor filter from the hose.
By Bob
GM Specialist
01/11/2022
Q: How to remove the air cleaner element?
A:
You need to install the filter element to the air cleaner housing and the air cleaner side cover. Then you can latch the air cleaner side cover retainers. After that, you can connect the engine harness electrical connector to the MAF sensor and install the air cleaner outlet duct.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the throttle body?
A:
After installing a new Throttle Body gasket and the throttle body, you can install the throttle body bolts and the thermostat bypass pipe. Then you can connect the engine harness electrical connector and install the air cleaner outlet duct.
Q: How to install the manifold absolute pressure sensor?
A:
After installing the MAP Sensor and the MAP sensor bracket and bolt/stud, you can connect the fuel injector harness electrical connector and install the intake manifold cover.
Q: How to remove the mass airflow sensor?
A:
You can remove the air cleaner outlet duct, disconnect the Mass Air Flow Sensor electrical connector, and remove the MAF sensor screws and the MAF sensor and O-ring seal.