2007 Buick Rainier Floor Pan

You should remove the front bucket seats, the front door sill plates, the center pillar trim panels, the floor console, the floor console bracket, and the carpet from the vehicle.

You should install the floor console bracket, the floor console, the center pillar trim panels, the front door sill plates, and the front bucket seats.

You should install the 4 nuts retaining the rear of the floor console bracket to the floor weld studs, the floor console, the child restraint tether anchors, the BEC, the tool kit carrier, the 3 tool carrier nuts to the floor studs, the lower rear quarter trim panels, the center pillar trim panels, the liftgate door sill plate, the rear door sill plates, the front door sill plates, the front bucket seats, the seat back, right and left side, the navigation control processor bracket to the floor panel, the rear seat cushions, the communication interface module, and the front seats.

You should remove the front seats., the rear seat cushions, the communication interface module, the navigation control processor bracket, the seat back, left and right side., the front bucket seats, the front door sill plates, the rear door sill plates, the liftgate door sill plate, the center pillar trim panels, the lower rear quarter trim panels, the tool kit carrier, the bussed electrical center junction block from the bussed electrical center (BEC) base, and the bussed electrical center base from the floor panel studs, the child restraint tether anchors, the bussed electrical center base and communication interface module electrical connectors through the pass-through holes in the carpet, the floor console to the floor console carrier, the 4 nuts retaining the rear of the floor console bracket to the floor weld studs, and the carpet from the vehicle.