Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2007 Buick Rainier 4WD Switch

2007 Buick Rainier 4WD Switch

My Vehicle Change Vehicle
2007 Buick Rainier
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Driveline, Axles & 4WD
  • Department
  • Brands
  • Prices

1 Product found

2 Q&A for 4WD Switch Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by
  • Dorman OE Solutions 4Wd Switch for 2007 Buick Rainier - 901-064

    Dorman® OE Solutions 4Wd Switch for 2007 Buick Rainier

    PartNumber: 901-064
    Product Specifications
    • Attached Lead Wires: No
    • Mounting Location: Dash
    • OE Part Number: 15066147, 15066148, 15087623, 15097405, 15132078, 15175465, 15194913, 15807881, 15944371, 25827385, 25965895
    • Package Contents: 1 Switch
    • Terminal Type: 11 Pins
    • UPC: 019495296423
    • Wiring Harness Included: No
    • Part Description: 2007 Buick Rainier OE Solutions 4Wd Switch
    More Info
    Vehicle Fitment
    • 2007 Buick Rainier | All Trims | All Engines
    $16.34

FAQ for 4WD Switch Repair

Q: How to remove the Transfer Case Shift Control Switch?
A:
You should remove the floor console, the trim plate, and the control switch.
By Bob
GM Specialist
01/11/2022
Q: How to install the Transfer Case Shift Control Switch?
A:
You should install the electrical connector to the control switch, the control switch in the trim plate, the trim plate, and the floor console.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How to install the Rear Axle Shaft?
A:
You should install the Axle Shaft into the rear axle housing, the new pinion shaft locking bolt, the rear axle housing cover and the gasket, the brake caliper, the rear wheel speed sensor, and the tire and wheel assembly.
Q: How to disassemble the Wheel Drive Shaft Outer Joint and Seal?
A:
You should wipe all grease away from the face of the CV Joint, spread the snap ring ears apart using J 8059 (or equivalent), place a brass drift against the cage, tap gently on the brass drift to tilt the cage, remove the first ball when the cage tilts and all of the balls, pivot the cage and the inner race 90 degrees to the centerline of the outer race, remove the inner race from the cage by rotating the inner race upward and degrease all of the CV joint parts.
Q: How to remove the Front Axle Lubricant?
A:
You should remove the engine protection shield, the fill plug, the drain plug, and the washer, and drain the fluid from the Differential carrier assembly.