2006 GMC Yukon | Denali, SL, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
$101.04MSRP: $175.87
You Save: $74.83 (43%)
FAQ for Timing Cover Repair
Q: What is the recommended torque for the engine front cover bolts?
A:
The recommended torque is 25 Nm (18 ft. lbs.).
By Bob
GM Specialist
02/11/2022
Q: What is the removal procedure for the engine front cover?
A:
You need to remove the water pump, the crankshaft balancer, the front cover bolts, and the front cover and gasket, discard the front cover gasket, and clean and inspect the engine front cover.
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: How to install the drive belt idler pulley?
A:
You need to install the drive belt Idler Pulley and bolt to the generator bracket, snug the bolt finger tight, install the drive belt, and tighten the drive belt idler pulley bolt.
Q: What is the removal procedure for the belt tensioner in the accessory?
A:
You need to remove the accessory drive belt, the drive Belt Tensioner bolts, and the drive belt tensioner.
Q: How to remove the camshaft?
A:
You need to install three bolts to the bolt holes in the front of the Camshaft, rotate and pull the camshaft out of the engine block, and remove the three bolts from the camshaft.