Part Description: 2006 Chevrolet Colorado Spark Plug Asm-Gasoline Engine Ignition
More Info
Vehicle Fitment
2006 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS
Notes: Gap 0.040; Platinum TT - Twin-Tip Technology Design w/Platinum Center Electrode & Titanium Enhanced Ground Strap
Center Electrode Core Material: Copper
Center Electrode Tip Material: Platinum
Ground Configuration: Twin-Tip
Ground Electrode Core Material: Nickel
Ground Electrode Quantity: 1
Ground Electrode Tip Design: Titanium Enhanced Twin-Tip
Hex Size: 16.0
Manufacturer Heat Range: 16
Pre-Gap Size: 0.040
Reach: 25.00
Resistance: 5000
Seat Type: Tapered
UPC: 042511045132
Part Description: 2006 Chevrolet Colorado Platinum Tt™ Spark Plug
More Info
Vehicle Fitment
2006 Chevrolet Colorado | All Trims | 4 Cyl 2.8L
2006 Chevrolet Colorado | All Trims | 5 Cyl 3.5L
FAQ for Spark Plug Repair
Q: What is the proper way to install the spark plug?
A:
The proper way is to measure the spark plug gap on the spark plugs to be installed, install the spark plugs to the cylinder head, and then install the ignition coils.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the spark plug?
A:
The procedure is to remove the ignition coils, clean the spark plug recesses with low-pressure air, remove the spark plugs from the cylinder head, and then inspect the spark plugs.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the engine oil and oil filter?
A:
The proper way is to lubricate the Oil Filter seal with clean engine oil, install the new oil filter, install the oil pan drain plug, install the oil fill cap, and then inspect the oil filter and oil pan drain plug areas for leaks.
Q: What is the removal procedure for the oil filter adapter?
A:
The procedure is to remove the oil filter, remove the engine oil pressure switch if necessary, remove the Oil Filter Adapter bolts, and then remove the oil filter adapter from the engine block.
Q: What is the removal procedure for the heated oxygen sensor position 2?
A:
The procedure is to disconnect the heated Oxygen Sensor (HO2S) electrical connector from the engine wiring harness electrical connector and the camshaft cover, and then remove the HO2S from the exhaust manifold.