Part Description: 2006 Chevrolet Cobalt Motor Asm-Sun Roof Actuator
More Info
Vehicle Fitment
2006 Chevrolet Cobalt | Base, LS, LT, LTZ, Sport, SS | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L GAS
FAQ for Sunroof Motor Repair
Q: How to remove the sunroof motor/actuator?
A:
You need to remove the headliner, disconnect the motor/actuator harness from the sunroof module, disconnect the electrical connector from the sunroof motor/actuator, remove the sunroof motor/actuator bolts, and remove the sunroof actuator from the sunroof module.
By Bob
GM Specialist
01/11/2022
Q: How to synchronize the Sunroof Motor?
A:
You need to plug the motor/actuator into the harness and provide power and position it in the vent detent mode only, remove the sunroof window, verify that the sunroof guide mechanisms are fully forward and in the vent position, install the sunroof motor/actuator and the sunroof window, operate the sunroof to verify proper operation.
By Bob
GM Specialist
01/11/2022
Q: How to handle it when the sunroof window is partially closed?
A:
If the sunroof window is partially closed, you need to remove the actuator first before moving the sunroof window forward.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the Starter Motor (RPOs L61/LE5)?
A:
The procedure is to disconnect the negative battery cable, remove the Starter solenoid terminal nut, remove the positive battery cable terminal from the starter, remove the starter solenoid wire terminal from the starter, remove the starter solenoid °S° terminal nut, the engine harness terminal from the starter, the starter bolts, and the starter.
Q: What is the installation procedure for the underhood electrical center or junction block bracket?
A:
The procedure is to position the underhood electrical center, tighten the underhood electrical bolts, connect the positive battery cables to the underhood electrical center, install the underhood positive battery terminal lug, install the cover to the underhood electrical center, and connect the negative battery cable.
Q: How to install the inflatable restraint steering wheel module coil?
A:
You need to install the wiper washer switch, install the headlamp/turn signal switch to the SIR coil module assembly, install the headlamp/turn signal switch screws, verify the SIR coil is in the center position, slide the SIR coil assembly on the steering column and snap into place, connect the wiper/washer harness connector, connect the headlamp/turn signal harness connector, connect the SIR coil harness connector to the SIR coil module assembly, install the steering column covers, the steering wheel, and the inflatable restraint steering wheel module.