Notes: Available Until Inventory Is Depleted;New replacement part; Rear
Housing Bore: 4.1060"
Sealing Surface Material: Molded Rubber and Metal
Shaft Diameter: 3.4350"
UPC: 023913754037
Part Description: 2006 Chevrolet Cobalt Rear Crankshaft Seal
More Info
Vehicle Fitment
2006 Chevrolet Cobalt | All Trims | 4 Cyl 2.0L
2006 Chevrolet Cobalt | All Trims | 4 Cyl 2.2L
2006 Chevrolet Cobalt | All Trims | 4 Cyl 2.4L
Show More
FAQ for Crankshaft Seal Repair
Q: What is the proper way to install the License Lamp (W/Step Bumper)?
A:
The proper way is to install the bulb, the lamp's retainer, and the lamp.
By Bob
GM Specialist
29/10/2022
Q: How to remove the Crankshaft Front Oil Seal?
A:
You need to remove the crankshaft balancer, then use a flat-bladed tool to remove the seal from the front cover.
By Bob
GM Specialist
29/10/2022
Q: What kind of special tools will be used in the replacement of the Crankshaft Front Oil Seal?
A:
You need to J 35268-A Camshaft/Front Main Seal Installer.
By Bob
GM Specialist
29/10/2022
FAQ for Other Repair Info
Q: Can you reuse the oil filter in the installation?
A:
No, you should install the new Oil Filter on the cap.
Q: What should be noticed before removing the Heated Oxygen Sensor-Position 1?
A:
The heated Oxygen Sensor may be difficult to remove when the engine temperature is less than 48°C (120°F).
Q: How to remove the Throttle Body Assembly?
A:
You need to remove the air cleaner outlet duct, and the intake manifold cover, disconnect the throttle actuator control (TAC) electrical connector and remove the Throttle Body bolts and the throttle body.