Notes: Not legal for use in Calif; Illegal for installation in NY on vehicles equipped w/Calif emission systems; Fed Emissions; w/1 converter;Not legal for use in Calif; Illegal for installation in NY on vehicles equipped w/Calif emission systems; w/1 converter
Catalytic Converter Overall Length: 36.5"
Converter Configuration: Direct Fit
Inlet Type: 3 Bolt Fixed Flange
O2 Sensor Port: Yes
Outlet Type: 2 Bolt Fixed Flange
Position: Center
UPC: 841809119490
Part Description: 2006 Chevrolet Cobalt Direct Fit Catalytic Converter and Pipe Assembly
Notes: CARB Executive Order D-193-142;Engine Family Number 6GMXV02.0018;Certification Level : LEV1 ULEV; OE Spec; Cutting & Welding Reqd During Installation
Air Tube Adaptable: No
Body Height: 4
Body Length: 9
Body Shape: Round
Body Type: Spun
Body Width: 4
Finish: Stainless Steel
Heat Shield Attached: No
Inlet Attachment: Weld-On
Inlet Diameter: 2.5
Inlet Orientation: Straight
Inlet Quantity: 1
Material: Stainless Steel
Outlet Attachment: Weld-On
Outlet Diameter: 2.5
Outlet Orientation: Straight
Outlet Quantity: 1
Overall Length: 9
Sensor Port Count: 0
Series: California
Substrate Material: Ceramic
Title: California Universal
UPC: 888563132808
Part Description: 2006 Chevrolet Cobalt Universal Catalytic Converter
Other Names: Catalytic Converter, Converter & Pipe
Item Dimensions: 36.4 x 10.5 x 6.4 inches
Item Weight: 14.90 Pounds
Fitment Type: Direct Replacement
Part Description: 2006 Chevrolet Cobalt 3Way Catalytic Convertor Assembly (W/ Exhaust Manifold P
More Info
Vehicle Fitment
2006 Chevrolet Cobalt | LS, LT, LTZ | 4 Cyl 2.2 L GAS
FAQ for Catalytic Converter Repair
Q: Can you reuse the gasket in the installation of the catalytic converter (RPO LE5)?
A:
You need to install a new gasket onto the muffler pipe studs.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when installing the catalytic converter to muffler pipe nuts?
A:
The recommended torque is 30 Nm (22 ft. lbs.).
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when installing the catalytic converter pipe to exhaust manifold nuts?
A:
The recommended torque is 50 Nm (37 ft. lbs.).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: Can you reuse the oil filter in the installation?
A:
No, you should install the new Oil Filter on the cap.
Q: What should be noticed before removing the Heated Oxygen Sensor-Position 1?
A:
The heated Oxygen Sensor may be difficult to remove when the engine temperature is less than 48°C (120°F).
Q: How to remove the Throttle Body Assembly?
A:
You need to remove the air cleaner outlet duct, and the intake manifold cover, disconnect the throttle actuator control (TAC) electrical connector and remove the Throttle Body bolts and the throttle body.