Part Description: 2006 Chevrolet Cobalt Cabin Air Filter
Vehicle Fitment
2006 Chevrolet Cobalt | All Trims | 4 Cyl 2.0L
2006 Chevrolet Cobalt | All Trims | 4 Cyl 2.2L
2006 Chevrolet Cobalt | All Trims | 4 Cyl 2.4L
Show More
FAQ for Cabin Air Filter Repair
Q: What is the proper way to install the passenger compartment air filter?
A:
You should install the new filter, close the passenger compartment filter door, snap the tab down to latch the door, and then raise the I/P compartment door. Slowly raise the door until the doorstops snap into their tracks.
By Bob
GM Specialist
29/10/2022
Q: How to remove the passenger compartment air filter?
A:
You need to open the I/P compartment, tilt the I/P compartment door down by squeezing in on each side of the bin, then lower the I/P compartment completely, and open the passenger compartment filter door by reaching through the opening in the rear of the I/P compartment and raising the tab until the door can be opened downward, finally remove the filter by sliding the filter out of the passenger compartment filter housing.
By Bob
GM Specialist
29/10/2022
FAQ for Other Repair Info
Q: How to install the blower motor?
A:
You need to install the Blower Motor into the motor cup that was cut out of the lower case, install the blower motor nuts, attach the service ring to the motor cup with the screws included in the kit, install the blower motor and service ring into the HVAC module using the screws included in the kit, install the lower blower motor cover, then install the lower blower motor cover retaining screws, and connect the blower motor electrical connector.
Q: How to remove the blower motor resistor?
A:
You need to disconnect the Blower Motor Resistor electrical connector, unsnap the blower motor resistor from the HVAC module and remove it.
Q: How to remove the Heater Assembly?
A:
You need to remove the HVAC module, the Heater Core cover heat stakes, the heater core cover, the heater core, and the lower HVAC case heat stakes, unsnap and open the passenger compartment filter door, and remove the lower HVAC case.