Notes: Fuel tank contamination is the leading cause of premature fuel pump failure. To reduce risk of contaminating the replacement pump, Delphi recommends cleaning the fuel tank before installing a new pump. Use of fuel tank cleaning kit FC01 is recommended.
Current Draw: 5
Flow Rating: 45 gph
Fuel Level Sender Assembly Included: Yes
Fuel Type: Gas
Gasket or Seal Included: No
In Tank or External: In Tank
Inlet Type: Strainer
Internal or External Strainer: Internal
Item Grade: Standard Replacement
Maximum Pressure: 57.0 PSI
Outlet Outside Diameter: 0.375''
Outlet Quantity: 1
Outlet Type: Quick Connect
Pump Type: Electric
Regulator Included: Yes
Resistance Ohms Empty: 280.0
Resistance Ohms Full: 15.0
Strainer Included: Yes
System Pressure: 58 psi
Terminal Gender: Male
Terminal Quantity: 6
Terminal Type: Blade
UPC: 689604233313
Vapor Pressure Sensor: Yes
Voltage: 12.0 VDC
Part Description: 2006 Chevrolet Aveo Fuel Pump Module Assembly
2006 Chevrolet Aveo | Base, LS, LT, Special Value | 4 Cyl 1.6 L GAS
FAQ for Fuel Pump Repair
Q: What is the installation procedure for the Fuel Gage?
A:
Install the fuel gage to the cluster assembly with the screws, install the instrument cluster lens and the face plate, install the instrument cluster, and connect the negative battery cable.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the Fuel Gage?
A:
Disconnect the negative battery cable, remove the instrument cluster, remove the instrument cluster lens and the face plate, and remove the screws and the fuel gauge from the cluster assembly.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What should you do after installing the fuel pump assembly clip?
A:
You should connect the fuel pump assembly connector.
Q: What should you do after installing the fuel pump assembly clip?
A:
You should connect the fuel pump assembly connector.
Q: What is the installation procedure for the Fuel Tank Pressure Sensor?
A:
Install the FTP sensor to the fuel sender assembly, connect the FTP sensor electrical connector, install the fuel pump access cover, install the rear seat, connect the negative battery cable, and install the fuel fill cap.