< Back ×
My Vehicle Change Vehicle
2005 Chevrolet Cavalier
< Back to View All
Hoods
- Department
- Prices
OEM (Genuine) 2005 Chevrolet Cavalier Lock
PartNumber: 22710142
Product Specifications- Other Names: Lock
- Item Dimensions: 8.2 x 4.6 x 2.4 inches
- Item Weight: 1.00 Pounds
- Fitment Type: Direct Replacement
- Replaces: 22650289
- Part Description: 2005 Chevrolet Cavalier Lock
Vehicle Fitment- 2005 Chevrolet Cavalier | Base, LS, LS Sport | 4 Cyl 2.2 L BI-FUEL, 4 Cyl 2.2 L GAS
FAQ for Hood Latch Repair
Q: How do you replace the hood rear side seal?
A:
You can open the hood, pull the rear side hood seal, remove the seal and clean any adhesive from the pinch-weld flange and hood hinge.
By Bob
GM Specialist
01/11/2022Q: What is the proper way to install the hood rear side seal?
A:
You can remove the protective backing paper, press the side hood seal until the adhesive is fully adhered, and close the hood.
By Bob
GM Specialist
01/11/2022Q: How do you install the hood hinge?
A:
You can position the hood hinge to the alignment marks on the fender, install the hood hinge to fender bolts, install the hood and align the hood if necessary.
By Bob
GM Specialist
01/11/2022Q: How do you install the hood latch striker?
A:
You can position the hood latch striker to the hood to the marks on the hood, install the hood latch striker bolts, adjust the hood latch striker and close the hood.
By Bob
GM Specialist
01/11/2022Q: How do you install the hood latch support?
A:
You can position the hood latch support in the vehicle, install the lower bolts and the upper bolts, install the hood latch, engage the airbag sensor, install the hood latch cover and install the hood close-out filler panel.
By Bob
GM Specialist
01/11/2022Q: What is the proper way to install the hood latch cover?
A:
You can install the hood latch cover, the hood latch cover retainers, and the hood close-out filler panel.
By Bob
GM Specialist
01/11/2022Q: How do you replace the hood latch cover?
A:
You can remove the hood closeout filler panel, the hood latch cover retainers, and the hood latch cover.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the plenum to hood seal?
A:
The procedure is to open the hood and pull the hood rear seal from the pinch weld.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the hood latch?
A:
The procedure is to open the hood, mark the hood latch location to the support bracket, remove the hood latch bolts, disconnect the hood latch release cable and remove the hood latch.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the hood latch striker?
A:
The procedure is to open the hood, mark the location of the hood latch striker on the hood, remove the hood latch striker bolts and remove the hood latch striker.
By Bob
GM Specialist
01/11/2022See more FAQs (11)