Notes: Measurement taken from end of CV joint flange face to end of CV joint flange face;with 25-9/16" (650 mm) Long Driveshaft;Supplied as new
Greasable: No
Length: 25.562"
Length (mm): 650
Material: Steel
Measurement Method: Measurement is taken from the centerline of the weld on one end to the centerline of the weld on the opposite end of the collapsed Prop Shaft
Product Condition: Remanufactured
Part Description: 2005 Cadillac SRX Remanufactured Driveshaft/ Prop Shaft
Part Description: 2005 Cadillac SRX Shaft Kit, Rear Wheel Drive
More Info
Vehicle Fitment
2005 Cadillac SRX | Base | 6 Cyl 3.6 L GAS, 8 Cyl 4.6 L GAS
FAQ for Driveshaft Repair
Q: What needs to be done before servicing the Propeller Shaft?
A:
You should raise and support the vehicle.
By Bob
GM Specialist
29/10/2022
Q: What should be noticed when installing the propeller shaft to the transfer case flange?
A:
Ensure that the coned end of the propeller shaft CV joint is installed into the transfer case flange.
By Bob
GM Specialist
29/10/2022
Q: What should be noticed when servicing the Propeller Shaft?
A:
The propeller shaft must be supported during removal and/or installation so that the CV joint does not articulate more than 8 degrees. Allowing the propeller shaft to articulate greater than 8 degrees could cause damage to the CV boot. Damage to the boot could lead to contamination or loss of lubrication which could lead to CV joint damage.
By Bob
GM Specialist
29/10/2022
FAQ for Other Repair Info
Q: What special tool will I be needing when servicing the Wheel Drive Shaft?
A:
You will be needing a slide hammer with an adapter, extension, Axle Shaft puller, and wheel hub remover.
Q: What should you do before cleaning and inspecting the differential housing for the mounting bolt threads?
A:
You should clean the Differential housing in the solvent.
Q: What special tool will I be needing when servicing the Wheel Drive Shaft Outer Joint and Seal?
A:
You will be needing drive shaft seal clamp pliers.