< Back ×
My Vehicle Change Vehicle
2005 Buick Rainier
< Back to View All
Light Relays, Switches & Control Modules
- Department
- Prices
OEM (Genuine) 2005 Buick Rainier Flasher
PartNumber: 15231201
Product Specifications- Notes: Rainier
- Other Names: Flasher
- Item Dimensions: 3.2 x 2.6 x 1.3 inches
- Item Weight: 0.50 Pounds
- Fitment Type: Direct Replacement
- Replaces: 12450284, 15101912
- Part Description: 2005 Buick Rainier Flasher
Vehicle Fitment- 2005 Buick Rainier | CXL, CXL Plus | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
$44.29 MSRP:$83.58You Save: $39.29 (48%)
OEM (Genuine) 2005 Buick Rainier AC Relay
PartNumber: 13500114
Product Specifications- Notes: Fuse Block-Engine Compartment, AC Compressor;Fuse Block-Engine Compartment, Fog Lamp;Fuse Block-Engine Compartment, Front Washer Pump;Fuse Block-Engine Compartment, Fuel Pump;Fuse Block-Engine Compartment, High Beam;Fuse Block-Engine Compartment, Horn;Fuse Block-Engine Compartment, Rear Washer Pump; Fuse Block-Instrument Panel, Park Lamp; All Models
- Item Dimensions: 3.8 x 2.2 x 0.7 inches
- Item Weight: 0.40 Pounds
- Fitment Type: Direct Replacement
- Replaces: 12193606, 19115080, 15328866, 12135034, 15393412, 12088567, 12135170, 19116057
- Part Description: 2005 Buick Rainier AC Relay
Vehicle Fitment- 2005 Buick Rainier | CXL, CXL Plus | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
$9.55 MSRP:$20.04You Save: $10.49 (53%)
FAQ for Flasher Units Repair
Q: How to install the Hazard and Turn Signal Flasher?
A:
You should position the flasher to the insulator panel, connect the electrical connector to the flasher and install the flasher retaining bracket to the insulator panel and the left closeout/insulator panel.
By Bob
GM Specialist
01/11/2022Q: How to remove the Hazard and Turn Signal Flasher?
A:
You should remove the left closeout/insulator panel and the flasher retaining bracket from the insulator panel, disconnect the flasher from the electrical connector and remove the flasher from the vehicle.
By Bob
GM Specialist
01/11/2022Q: How to remove the Hazard and Turn Signal Flasher?
A:
You should remove the left closeout/insulator panel and the flasher retaining bracket from the insulator panel, disconnect the flasher from the electrical connector and remove the flasher from the vehicle.
By Bob
GM Specialist
01/11/2022Q: How to install the Hazard and Turn Signal Flasher?
A:
You should position the flasher to the insulator panel, connect the electrical connector to the flasher and install the flasher retaining bracket to the insulator panel and the left closeout/insulator panel.
By Bob
GM Specialist
01/11/2022