2005 Buick Park Avenue Vehicle Speed Sensors

First, you need to install the mount and the mount bracket onto the vehicle and position it in place, apply thread lock compound GM P/N 12345493 or equivalent, to the rear transmission bracket bolts. Then, please install the retaining bolts to the mount bracket, install the Transmission Mount lower bolts and nut, the transmission mount upper nuts onto the mount, and remove the transaxle support stand. Finally, you should install the power steering return hose and the power steering pressure hose onto the rack and pinion, install the power steering gear heat shield, and lower the vehicle.

First, you need to place the drain pan under the transaxle oil pan, loosen the rear oil pan bolts about 4 turns, and lightly tap the oil pan with a rubber mallet or pry to allow the fluid to drain. Then, please inspect the fluid color, remove the oil pan and the gasket, and remove the oil filter. Finally, you should check the oil filter seal for damage or wear, and remove the seal.

First, you need to pull the plastic cap back from the quick connect fitting and down along the cooler line about 5 cm (2 inches). Then, please pull on one of the open ends of the retaining ring to rotate the retaining ring around the quick connect fitting until the retaining ring is out of position and can be completely removed. Finally, you should remove the retaining ring from the quick connect fitting, discard the retaining ring, and pull the cooler line straight out from the quick connect fitting.