< Back ×
My Vehicle Change Vehicle
2005 Buick Park Avenue
< Back to View All
Hoods
- Department
- Prices
OEM (Genuine) 2005 Buick Park Avenue Latch
PartNumber: 16634628
Product Specifications- Other Names: Latch, Lock
- Item Dimensions: 9.4 x 7.0 x 4.2 inches
- Item Weight: 1.80 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2005 Buick Park Avenue Latch
Vehicle Fitment- 2005 Buick Park Avenue | Base, Ultra | 6 Cyl 3.8 L GAS
FAQ for Hood Latch Repair
Q: How to adjust the Hood Latch?
A:
First, you need to slowly lower the hood onto the latch in order to achieve the proper cross-vehicle adjustment of the hood latch. Then, please raise the hood and tighten the bolts.
By Bob
GM Specialist
01/11/2022Q: How to remove the Hood Latch Support?
A:
First, you need to remove the hood latch assembly. Then, please remove the bolts retaining the hood latch support. Finally, you should remove the hood latch support.
By Bob
GM Specialist
01/11/2022Q: How to remove the Hood Latch Striker?
A:
First, you need to mark the location of the striker on the underside of the hood panel with a grease pencil. Then, please remove the bolts retaining the striker to the hood, and remove the striker from the hood.
By Bob
GM Specialist
01/11/2022Q: How to install the Hood Latch?
A:
First, you need to install the hood latch release cable to the latch assembly. Then, please position the latch to the vehicle and install the bolts retaining the latch. Finally, you should close the hood, inspect the operation of the latch, and adjust the latch.
By Bob
GM Specialist
01/11/2022Q: How to install the Seal-Hood Front?
A:
First, you need to install the front hood seal. Then, please install the push-in retainers.
By Bob
GM Specialist
01/11/2022Q: How to install the Seal-Fender to Hood?
A:
First, you need to install the fender seal. Then, please install the push-in retainers to the fender seal.
By Bob
GM Specialist
01/11/2022Q: How to remove the Seal-Hood Rear Side?
A:
First, you need to open the hood. Then, please pull the rear side hood seal from the pinch-weld flange and motor compartment flange, and remove the rear side hood seal from the vehicle. Finally, you should clean any adhesive from the pinch-weld flange and motor compartment flange surface.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the bolts retaining the latch?
A:
The recommended torque is 18 N.m (13 lb-ft).
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the lower hinge bolts?
A:
The recommended torque is 11 N.m (97 lb in).
By Bob
GM Specialist
01/11/2022Q: How to install the Seal-Hood Rear?
A:
First, you need to remove the protective backing paper from the adhesive on the new rear side hood seal. Then, please press the seal to the flange to install the rear hood seal.
By Bob
GM Specialist
01/11/2022See more FAQs (17)