2005 Buick Park Avenue Door Lock Switch

First, you need to remove the door trim panel, the door control module, and the water deflector. Then, please remove the check link to the pillar fasteners and remove the close-out grommet. Finally, you should remove the check link to the door fasteners and remove the Door Check link through the inside of the door.

First, you need to remove the trim panel, the water deflector, and the cover plug, disconnect the handle rod from the outside handle, and disconnect the lock cylinder rod. Then, please insert the key into the key cylinder, rotate the key toward the front of the car until the key stops, and remove the outside door handle fasteners. Finally, you should flex the lower rivets to the side to allow the ribs to disengage from the outer panel flange, remove the outside door handle, and remove the lock cylinder from the outside door handle.

First, you need to remove the door trim panel, and the water deflector, disconnect the door latch electrical connectors, the power window motor electrical connector, and the front door speaker electrical connector, and disconnect the wiring harness clips from the inner door panel. Then, please pull the rubber conduit and the wiring harness out through the opening at the front of the door, remove the door check link bolt, and support the door. Finally, you should remove the hinge to the door nuts, remove the door, remove the hinge bolts from the pillar, and remove the hinge.