2005 Buick Park Avenue Brake Disc

First, you need to remove the tire and wheel assembly. Then, please remove the brake caliper from the mounting bracket and support the brake caliper. Finally, you should remove the brake caliper bracket assembly and the brake rotor.

First, you need to remove the tire and wheel assembly. Then, please remove the brake caliper and bracket from the vehicle, and support the caliper assembly away from the rotor. Finally, you should remove the brake rotor.

First, you need to follow the brake lathe manufacturer's recommended speed setting for applying a non-directional finish. Then, please use moderate pressure to apply the non-directional finish. If the lathe is equipped with a non-directional finishing tool, you need to apply the finish with 120-grit aluminum oxide sandpaper. If the lathe is not equipped with a non-directional finishing tool, you need to apply the finish with a sanding block and 150-grit aluminum oxide sandpaper. Finally, you should clean each friction surface of the brake rotor with denatured alcohol or an equivalent brake cleaner.

First, you need to clean any rust or corrosion from the wheel hub surface. Then, please install the brake rotor over the wheel studs onto the wheel bearing flange, and install the brake caliper bracket assembly. Finally, you should install the brake caliper to the brake caliper bracket assembly, and install the tire and wheel assembly.

First, you need to select a smooth road with little or no traffic and accelerate the vehicle to 48 km/h (30 mph). Then, please use moderate to firm pressure to apply the brakes to bring the vehicle to a stop. Finally, you should repeat doing so until approximately 20 stops have been completed, and allow sufficient cooling periods between stops to properly burnish the brake pads and rotors.