2005 Buick LeSabre Idle Control Valve

You should install the accelerator control cable through the bulkhead, install the snap retainer through the bulkhead, install the accelerator control cable through the slot in the accelerator pedal lever, assemble the dash panel insulator retainer to the accelerator control cable, push (from the passenger compartment) the retainer over cable lever end fitting and up cable until the retainer snaps onto the flange of cable dash fitting, check for complete throttle opening and closing positions by operating the accelerator pedal, install the accelerator control cable to the Throttle Body lever, install the accelerator control cable to the accelerator cable bracket, install the accelerator control cable to the right slot on top of washer bottle, install the accelerator control cable to the retaining clip and install the left closeout/insulator panel.

You should install the Air Filter element into the air cleaner assembly, install the air cleaner element cover, secure the air cleaner element cover by pressing down on the retaining clips, and install the intake duct.

You should turn OFF the ignition, remove the fuel injector sight shield, disconnect the MAP Sensor electrical connector, carefully bend the locking tabs holding the MAP sensor to the PCV valve cover just enough to remove the MAP sensor, and pull the MAP sensor straight out of PCV valve cover.